XC90 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Body Control Module: Service and Repair
Driver Door Module (DDM), Replacing
Driver door module (DDM), replacing
Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
which is required to order the correct software.
Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the
cause of the fault.
Removing the driver door module (DDM)
the door panel, see Panel front side door, replacing See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
the nut and screw holding the door module in place.
Pull up the rear edge of the control module.
Pull the control module backwards and upwards.
Detach the control module from the mounting on the door panel.
Press up the control module.
Disconnect the catches. Lift the upper panel from the control module.