Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 3
background image

Install:

-

the lever on the gear shift linkage rod. Tighten. See See: Specifications/Mechanical Specifications/Automatic Transmission/Transaxle/System
Specifications/Tightening Torque 

-

the gear selector cable and bracket on the transmission using 2 M8 screws. Tighten

-

the ball joint for the gear selector cable on the lever. Press into place by hand.

Installing the air cleaner (ACL) housing

Install the air cleaner housing (ACL) assembly with the intake pipe and connector.

Checking diagnostic trouble codes (DTCs)

Check and erase any diagnostic trouble codes (DTCs).
Check the gear-shift position sensor positions: Use the on-board diagnostic (OBD) system.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Locations > Page 1973

< PREV PAGE NEXT PAGE >