volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Charging/Computer Controls - DTC CEM-DD21 Stored|Page 23859 > < Charging/Computer Controls - DTC CEM-DD21 Stored|Page 23857
Page 21
background image

Hint: 

Slightly loosen the screws so that you can adjust in small steps by tapping the striker. Use the existing punch marks or use some tape to keep track of
the movements (see picture).

Step 1.2 Check overall door fitting:

Check the 'load' on the door by closing it with the lock mechanism disengaged as described under step 1.1. There should be no resistance felt until the
door is less than approximately 0.30" (8 mm) ajar.

If you do feel resistance, try to locate the source by listening for squeaky noises from squeezing the door seal or the sill seal (see also step 1.3).

In some cases the rear door might be too far inward at the upper side of the B-pillar.

Service: 

Charging/Computer Controls - DTC CEM-DD21 Stored|Page 23859 > < Charging/Computer Controls - DTC CEM-DD21 Stored|Page 23857