XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Note! Only applies to vehicles with 6-cylinder engines.
Pay attention to the following when removing propeller shaft
Follow instructions. Refer to: Propeller shaft, special information See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Description and Operation
Note! Only applies to cars with AWD.
Remove:
-
the 4 screws for the propeller shaft
-
the propeller shaft
-
the power supply cable and the clamps for the Active on Demand coupling (AOC).
Lowering the sub-frame
Position a lifting table under the sub-frame.
Apply the lifting table so that the load is taken off the sub-frame screws. Remove the bracket for the fuel pre-filter and brake pipe. Remove the sub-frame
screws with accompanying washers and brackets. Carefully lower the sub-frame approximately 100 mm.
