XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Remove:
-
the oil filter. Use tool 999 5679 Oil filter spanner See: Tools and Equipment/999 5679 Oil Filter Spanner
-
the screws holding the oil pump to the intermediate section.
Carefully tap the side of the oil pan with a rubber mallet.
Lift out the oil pan.
Removing the suction pipe from the oil pump
Remove:
-
the O rings for the oil ducts
-
the retaining screws holding the suction pump to the intermediate section. Work / lift out the suction pipe
-
the O-ring for the suction pipe.
Check the pipe and the strainer. Check for cracks and impurities.
Checking markings
Install the two old screws for the flywheel and carrier plate at the rear edge of the crankshaft.
Turn the crankshaft so the piston in cylinder 1 is at bottom dead center (BDC).
Check that there are markings on the cap and connecting rods. Check which way the markings are positioned (exhaust and intake side). Make a note of
this.
