XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Wipe clean the bearing recesses in the block and the intermediate section.
Check that the components are clean and undamaged.
Check the classification of the block and crankshaft.
The classification marking is at the rear edge of the block and the crankshaft. The classification is read from digit 1 to 7. The first letter after digit 1 is the
classification of main bearing 1. The bearing recesses are numbered starting at the front of the engine.
Selecting bearings
Note! Always use new bearings.
Bearing halves with grooves are always installed in the engine block.
Install the main bearings in the cylinder block and the intermediate section. See the table. The axial bearing is positioned at bearing recess 5
1. Classification cylinder block
2. Classification crankshaft
3. cylinder block
4. Intermediate section
Example. The marking on the block at bearing position 1 is B. The marking on the crankshaft at the corresponding bearing position is C. This gives a red
marked bearing in the block and a yellow marked bearing in the intermediate section.
Note! The thickest of the bearing halves shall always be installed in the intermediate section. This is to keep the centre line as straight as