XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
Apply liquid gasket 11 61 059 on the oil sump. Use roller 951 2767 Roller See: Tools and Equipment/951 2767 Roller. The surface must be completely
covered without any excess. Install the oil sump and install all bolts.
Tighten the screws. Start with the rear edge of the sump and work alternately forwards.
Installing the oil cooler
Install:
-
new sealing rings in the oil pan
-
the oil cooler. Tighten the screws
-
the oil filter.
Cleaning
Caution! Cleaning shall always be done in the direction around the flange, not in and out. No grinding tools or similar may be used. It is
extremely important that there is no remaining thread sealant or other dirt, as this may cause leakage.
Note! Use emery cloth 9511024 to clean the crankshaft end.
If necessary, wash off the oil on the rear cylinder block surface. Blow clean using compressed air.
When cleaning, work around the shaft journal, not in and out. It is essential that any residue from the emery cloth and any other contaminants are
completely removed before the new sealing ring is installed.
