XC90 AWD L5-2.5L Turbo VIN 59 B5254T2 (2005)
-
the wheel sensor (10 Nm)
-
the wheel sensor wiring in the clip on the brake hose and on the tank.
Secure the new connector to the loose cable/wire.
Pull up the sensor connector between the fuel tank and the body.
Disconnect the cable / wire from the connector.
Install the cover over the level sensor. Tighten the nuts.
Connect the wiring and the connectors.
Applies only when replacing the left-hand sensor
Remove the block from under the seat frame.
Install:
-
the 8 seat frame screws. Tighten to 50 Nm
-
the 2 seat frame screws. Tighten to 24 Nm.
Finishing
Fold the carpet down.
Install:
-
the center rear seat. See Upholstery backrest cushion center (second row), replacing See: Body and Frame/Seats/Seat Cover/Service and
Repair/Rear Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Center (Second Row), Replacing
-
the outer rear seat. See Upholstery backrest cushion outer (second row) See: Body and Frame/Seats/Seat Cover/Service and Repair/Rear Seat,
Passenger Seat, Seat/Upholstery Backrest Cushion Outer (Second Row).
Install the wheels. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Function test
Check the function. See Wheel sensor front, replacing See: Wheel Sensor Front, Replacing.