volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Propeller Shaft, Replacing|Page 12171 > < Drivetrain - Revised Driveshaft Removal/Installation|Page 12168
Page 1
background image

Drive/Propeller Shaft: Service and Repair
Propeller Shaft, Replacing

Propeller shaft, replacing

Special tools:

951 2940 Counterhold See: Tools and Equipment/951 2940 Counterhold 
999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold 

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.

Removal

Removing the front member

Remove the front member from the body, exhaust pipe and three-way catalytic converter (TWC). Remove the brake pipe from the mountings in the
member.

Removing the front propeller shaft

Note! If the same propeller shaft is to be reinstalled. Mark the propeller shaft CV joint in relation to the bevel gear flange.

Remove the screws from the propeller shaft.
Use counterhold 999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold.

Removing the rear section of the exhaust system

Propeller Shaft, Replacing|Page 12171 > < Drivetrain - Revised Driveshaft Removal/Installation|Page 12168