XC90 AWD L6-3.2L VIN 98 B6324S (2007)
The control module has a built-in diagnostic system, Volvo Diagnostic, which continuously monitors internal functions as well as input and output
Diagnostic trouble codes (DTCs)
A diagnostic trouble code (DTC) is stored if the control module detects a fault. A fault which is detected in the most recent operating cycle is defined as
permanent. Other faults which are detected are defined as intermittent.
If for some reason a fault disappears after being stored in the control module as a permanent diagnostic trouble code, the information remains stored in
the control module. If a fault is no longer permanent, the diagnostic trouble code remains as intermittent.
Reading and erasing diagnostic trouble codes (DTCs)
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function.
Diagnostic trouble codes (DTCs) can only be erased once all the diagnostic trouble codes (DTCs) have been read off at least once.
Note! Certain functions are unavailable until the diagnostic trouble codes (DTCs) have been erased.
Reading off the parameters
This function is used to read the status or value of parameters. The status or value can be presented digitally.
Reading off the control module identification
The diagnostic tool identifies control modules by reading off a number of codes from the control module memory.
The codes contain information about the control module:
hardware P/N (control module without software)
hardware serial number (control module without software)
diagnostic software P/N
Reading off extended diagnostic trouble code (DTC) information
This function can be used to read parameters, status identifiers and counters stored at the same time as a diagnostic trouble code (DTC). These are called