XC90 AWD V8-4.4L VIN 85 B8444S (2005)
the wheel sensor (10 Nm)
the wheel sensor wiring in the clip on the brake hose and on the tank.
Secure the new connector to the loose cable/wire.
Pull up the sensor connector between the fuel tank and the body.
Disconnect the cable / wire from the connector.
Install the cover over the level sensor. Tighten the nuts.
Connect the wiring and the connectors.
Applies only when replacing the left-hand sensor
Remove the block from under the seat frame.
the 8 seat frame screws. Tighten to 50 Nm
the 2 seat frame screws. Tighten to 24 Nm.
Fold the carpet down.
the center rear seat. See Upholstery backrest cushion center (second row), replacing See: Body and Frame/Seats/Seat Cover/Service and
Repair/Rear Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Center (Second Row), Replacing
the outer rear seat. See Upholstery backrest cushion outer (second row) See: Body and Frame/Seats/Seat Cover/Service and Repair/Rear Seat,
Passenger Seat, Seat/Upholstery Backrest Cushion Outer (Second Row).
Install the wheels. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Check the function. See Wheel sensor front, replacing See: Wheel Sensor Front, Replacing.