XC90 AWD V8-4.4L VIN 85 B8444S (2005)
-
the solenoid valve connector
-
the 1x screw. Remove the electrical cable mounting for the solenoid valve. Note how the electrical cable was routed
-
the snap ring.
Hint: Pry up the solenoid valve. Use a screwdriver (as illustrated).
Pull the solenoid valve straight up. Remove the solenoid valve.
Installation
Note! For tightening torques, see: See: Body and Frame/Specifications
Installing the solenoid valve
Hint: Lubricate the O-rings on the solenoid valve. Use compressor oil.
Install:
-
the solenoid valve by twisting backwards and forwards, under light pressure, until it bottoms enough for the groove for the snap ring to be visible.
-
the snap ring
-
the electrical cable for the solenoid valve in its mounting as noted. Tighten the screw
-
the connector
Finishing
Installing the compressor and test running
Install the compressor. See: Compressor, replacing, B8444S See: Heating and Air Conditioning/Compressor HVAC/Service and Repair.
Test run the compressor. Check the function.
