XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Connect the connector that was disconnected from the amplifier to the connector on the new cable harness.
-
Take a piece of foam tape from the kit and cut in the middle. Place a cut off piece of foam tape around the connectors.
-
Connect the other connector to the amplifier.
-
Reinstall the amplifier and the seat side piece.
Applies to left-hand drive cars
-
Route the two 4-pin connectors straight through the tunnel console.
Applies to right-hand drive cars
-
Route the two 4-pin connectors straight forward at the side of the tunnel console.
-
Route the connector with fiber optic cable straight through the tunnel console.
-
Connect the connector to the control module.