XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Locate the 4-pin gray, pre-routed connector for the power supply. It is taped to the thick cable harness under the dashboard.
-
Connect the cable harness to the pre-routed connector (1).
-
Tape one cut piece of foam tape around the connectors.
The pre-routed connector is already connected on certain versions. Disconnect it and then connect both the connectors from the new cable harness
in-between. Secure the connector (2) on the car's existing cable harness using a cable tie.
-
Place any excess under the carpet.
Steps 31-36 apply when connecting to the USB/iPod player located in the glove compartment.