XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Reinstall:
-
the left-hand side panel using the screws and cover. Tighten the screws in the load securing eyelets. Tighten to 24 Nm (18 lbf ft).
-
the covers for the load securing eyelets.
-
D-post panel with connector.
-
the connector for the rear roof lighting (if applicable).
-
the rear headlining.
-
C-post panel.
-
protective cover and bracket for the battery.
-
side floor hatch and folding panel.
-
storage compartment and floor hatch.
Checking the trailer connector
7-pin connection
1. Brake lamp/Left-hand indicator lamp
2. Ground
3. Spare (Brake lamp, Electric brakes)
4. Brake lamp/Right-hand indicator lamp
5. Charging
6. Position lamps
7. Spare (Reversing lamp)
The cable to pin 3 is blue (BL) and the cable to pin 7 is violet (VO). They are taped to the wiring approximately 1 meter from the connector.
4-pin connection
1. Brake lamp/Right-hand indicator lamp
2. Brake lamp/Left-hand indicator lamp
3. Position lamps
4. Ground
Note! The following steps (16-25) only apply if further functions are desired. These parts are not included in the kit. Specified part numbers can
be purchased separately from Volvo dealerships.
Steps 16-23 only apply if electric brakes are to be installed.