XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Make sure the cable harness curves around the lower edge of the bumper as shown in the illustration.
Note! If the cable harness is stretched too tightly, it can scrape against the lower edge of the bumper and become damaged.
Note! On the XC90 Executive, T-wiring is already installed in the fuse holder. As this is a cable with a black connector taped to it. The tow bar
wiring's black connector is then connected to this.
-
Detach the trailer module (TRM) from the Velcro fastener on the floor along the rear edge of the left-hand rear wheel housing.
-
Plug in the tow bar wiring connectors:
-
green (GN) and grey (GR) connectors to the control module.
-
black (SB) connector to the fuse holder.
-
Reinstall the control module.
-
Secure the excess cable with a tie strap from the kit.
-
Insert fuses from the kit in the following positions in the fuse holder (REM):
-
20A in position 20 (mini fuse) if the charging function will be used
-
25A in position 29
-
25A in position 30.
