XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Remove the drain hose (1) from the battery.
-
Remove the rubber seal (2). It will not be re-used.
-
Pull off the small, thin rubber strap on the new rubber seal.
-
Insert the old drain hose through the new rubber seal. Make sure the hose is not obstructed and that it is not folded.
Illustration A
-
Route the cable harness from the tow bar connector through the hole in the floor.
-
Adjust the position of the rubber seal (1) so that there is not excessive cable slack under the car.
-
Install the rubber seal in the hole.
-
Route the cable harness as illustrated. Insert it through the hole along the rear edge of the left-hand cargo floor support.
-
Secure the cable harness to the cable harness behind the battery with tie straps (2) from the kit.
Illustration B
-
Connect the routed ground cable to the grounding point (3) behind the battery and tighten the grounding screw securely.
-
Connect the drain hose (4) to the battery.