XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Installing the front bumper casing
Note! For tightening torques, see Specifications See: Specifications.
Install:
-
the foam for the rear section
-
the rear section on the casing.
Press the 31 hooks and 2 clips into place.
Install:
-
the washer hose
-
the high-pressure cleaner
-
the 4 screws and 2 clips for the high-pressure cleaner
-
the license plate.
Tighten the screws.
Install:
-
the quick-release connector for the washer hose
-
the 2 connectors for the fog lamp.
Connect the additional engine block heater (if applicable).
Secure the bumper and install the 2 screws loosely.
Press the hooks into place on both sides of the bumper.
Hint: Guide in the sides of the bumper from above.
Install:
-
the 2 M8 screws. Tighten
-
the 2 side panels
-
the 2 clips under the car
-
the 2 grilles
-
the 2 covers for the high-pressure cleaner.
Hint: Pull out the washer nozzle using pliers and secure the cover. Carefully release the washer nozzle.
Check that the headlamp washer is working.