XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Remove the bolt for the drive shaft. Use a screwdriver in the brake disc as counterhold. Tap the drive shaft into the hub slightly. Use a brass drift.
Removing the link arm from the wheel spindle on both sides
Remove the bolt to the link arm. Use a Torx wrench as counterhold to avoid damaging the rubber gaiter.
Loosen the ball joint pin from the link arm. Use: 999 7062 Separator See: Tools and Equipment/999 7062 Separator.
Fit the cap nut, 7062-1, for the ball joint pin. Tighten the nut against the link arm. Then turn back one turn so that clearance is created between the cap
nut and link arm. Place the puller on the link arm and loosen the ball joint from the link arm.
