XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Detach the link arm from the ball joint pin.
Pull down the link arm. Use: 999 7076 Lever See: Tools and Equipment/999 7076 Lever and move the wheel spindle to the side, and install the
protective sleeve: 999 5562 PROTECTIVE SOCKET See: Tools and Equipment/999 5562 Protective Socket on the ball joint pin at the same time. Keep
it in position using the ball joint nut.
Removing the steering gear from the subframe
Remove:
-
the nuts, x4
-
the bolt, x1.
Removing the subframe
Caution! Ensure that no pipes or cables are under load or are trapped when lowering the sub-frame.
Release:
-
the 2 x heated oxygen sensor (HO2S) connectors from the rear edge of the subframe
-
the heated oxygen sensor (HO2S) connector from the front edge of the subframe.
Remove the bolt to the ground cable bracket on the front edge of the subframe.
Position a lifting table under the subframe.