XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Detach the right-hand front door's sill trim panel. Pull it away starting at the front edge until the clip there has released. Continue backwards until
the remaining clips have released.
-
Unhook it from the B-pillar panel and place it to one side.
-
Push the carpet to one side by the right-hand front seat.
-
Press out the rubber grommet (1) under the insulation mat.
-
Remove the lower piece of tape, which is fitted where the bracket shall be screwed in.
-
Take the bracket and screw from the kit. Install the bracket in the existing weld nut, from where the piece of tape was removed.
-
Turn the bracket so that it is fitted as illustrated.
-
Install the connector loosely and check that it is fitted on straight, with the internal power connector forwards.
-
Tighten the bracket to 10 Nm (7 lbf.ft.).
-
If the car is equipped with a child seat mounting then the bracket for the passenger compartment connector socket must be fitted over this and
secured with an M6 screw. Tightening torque 10 Nm (7 lbf.ft.).