XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to all models
-
Connect the cable for the front socket to socket (1) on the branch connector. Firmly press the connector in and press in a locking sleeve from the
kit over the joint.
-
Connect the long cable for the passenger compartment connector socket from the kit to any connector (2 or 3) on the branch connector. Firmly
press the connector in and press in a locking sleeve from the kit over the joint.
-
Connect the cable for the engine block heater to the remaining connector on the branch connector. Firmly press the connector in and press in a
locking sleeve from the kit over the joint.
Applies to all models
-
Position the branch connector with the cables underneath the plate under the headlamp. The two parallel sockets must be turned forward and the
cable from the front engine block heater socket turned backward.
Applies to cars with 8-cylinder engine
-
Route the new cable for the passenger compartment connector socket on to the brake fluid reservoir the same way as the existing cable for the
engine block heater.
Applies to cars with 6-cylinder engine
-
Route the cable as shown in Illustration 18.
Applies to all models
-
Take a screw, nut and washer from the kit. Secure the branch connector in the hole in the plate (1).
-
Take a new tie strap from the kit and replace the tie strap removed in steps 12 and 14 respectively.