XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with 8-cylinder engine where engine block heater is installed
-
Remove the locking sleeve over the joint on the cables for the engine block heater. Pull the cables away from each other.
Applies to cars with 6-cylinder engine where engine block heater is installed
-
Remove the tie strap securing the cable to the front engine block heater socket.
-
Pull the cable forward.
-
Remove the locking sleeve over the joint on the cables for the engine block heater and pull the cables away from each other.
Applies to all models
-
Grease in the O-ring on the connector for the front engine block heater socket and both connectors on the branch connector from the kit using low
temperature grease P/N 1161427.
Note! Do not get any grease on the surfaces of the connector.