XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Press in a clip from the kit on the edge of the plate on the right-hand side of the wheel housing, under the bending rubber hose of the water
evacuation pipe.
-
Take the radiation shield from the kit and cut it to a length of 300 mm (11 13/16").
-
Pull the radiation shield onto the end of the cable.
-
Grease in the rubber grommet using low temperature grease P/N 1161427 in order to make it easier to insert the cable and rubber grommet into the
hole in the cowl panel.
-
Guide the cable into the rubber grommet.