XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Guide the cable into the hole in the cowl wall and press the rubber grommet into place in the hole, either by pulling it into place from inside the
passenger compartment, or carefully pressing it into place with a long large screwdriver/wide end of a short pry bar.
Note! These must not be sharp or they can damage the cables/rubber grommet.
-
Adapt the length of the cable from the rubber grommet, at the installed clip and out in the engine compartment.
-
Press the cable for the passenger compartment connector socket into the installed clip. Make sure that the cable with the radiation shield is firmly
pressed into the clip and does not slide out.
Caution! Check that the cable is routed so that it does not come into contact with the alternator belt, or chafe against sharp edges in the engine
compartment.
-
Reinstall the small protective panel in the wheel housing.
-
Remount the wheel and tighten the bolts to 140 Nm (103 lbf.ft.).
-
Reinstall the engine splash guard and torque tighten the screws to 25 Nm (18.5 lbf.ft.).
-
Connect and reinstall the left-hand headlamp.
-
Take the grey tie straps from the kit and tighten the radiation shield to the cable
