XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with a passenger compartment connector socket
-
Fold aside the carpet at the right-hand front seat to access the grommet in the engine compartment. It is slightly to the left in the lower edge of the
sound proofing.
-
Remove the locking sleeve between the cable and passenger compartment connector socket.
-
Push out the cable to the engine compartment.
-
Detach the rubber grommet from the cable.
-
Cut off the larger top of the rubber grommet.
-
Install the cable in the grommet.
-
Reinsert the cable into the passenger compartment.
-
Connect the cable to the passenger compartment connector socket and press the sleeve over the splice.
-
Press the rubber grommet into place.
Applies to cars without a passenger compartment connector socket
-
Cut off the pre-punched engine insulation.
-
Remove the rubber grommet that is in front of the insulation.
-
Insert the new cable in the lead-in hole to the passenger compartment and press the rubber grommet, positioned on the cable, into the hole.
Steps 13-37 apply to the XC90