XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Roll up and clamp the excess cable for the front socket using two new tie straps on the reverse of the left-hand side of the bumper as illustrated.
-
Press the news clips into the subframe in place of the removed clips.
-
Place the cables in the clamps - do not tighten them yet.
-
Lubricate the O-ring on the thicker cable connector using low temperature grease, part no. 1161427.
-
Connect the thicker cable to the heater cable. Press the cable securely and press a new locking sleeve over the splice.
-
Separate the cables evenly in the clamps and tighten.
-
Clamp the two cables to each other as illustrated, use two new tie straps.
-
Clamp the routed cable together with the cable for the engine block heater. Use six new tie straps along the subframe.
-
Remove the centre console's right-hand side panel (1) by turning the clip in the rear edge 45°. Pull the panel out at the rear edge and then straight
back.
-
Remove the sound barrier (2) by first removing the three screws (3). Prize it away from the three clips on the rear and pull the panel backwards.
-
Remove the panel (4) in the right-hand front door sill by pulling it away backwards at its top and front edges. Following which, pull the panel up
so that all the clips detach.