XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to all models
-
Remove the locking sleeves over the joints on the branch connector and pull the cables away from it.
-
Place the branch connector to one side, it shall not be re-used.
Applies to all models
-
Take the relay with cable from the kit.
-
Grease the O-ring on the connector for the front socket and both connectors on the relay using low temperature grease, part no. 1161417-9.
Note! Do not get any grease on the surfaces of the connector.
Applies to all models
-
Connect the cable (1) from the front socket to the relay.
-
Connect the cables to the engine block heater and passenger compartment connector socket to either of the sockets (2) or (3) on the relay and press
them in firmly.