XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with V8 engine
-
Take three locking sleeves from the kit and press them in over the cable joints.
Applies to cars with 5 and 6-cylinder engines
-
Take three locking sleeves from the kit and press them in over the cable joints.
-
Take a tie strap (1) from the kit and clamp the electrical cable securely with the ground cable to one of the cables for the engine block heater
/passenger compartment connector socket.
Applies to cars with V8 engine
-
Take the relay with cables and fit it on the underside of the plate beneath the headlamp. Fit the relay with the side against the plate that allows the
connector to be accessible.
-
Take a screw, washer and nut (1) from the kit. Tighten the relay to the plate.
-
Guide the relay's ground cable (2) down on the left-hand side of the side member.
-
The long thin cable (3) from the relay is routed in the same direction as the cable for the heater and passenger compartment socket.
-
Clamp the ground cable with the cable to the front socket using a tie strap from the kit.
