XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Applies to cars with 5 and 6-cylinder engines
-
Take the relay with cables and place it on the underside of the plate (1). Fit the relay with the side against the plate that allows the connector to be
accessible.
-
Take a screw, washer and nut (2) from the kit. Tighten the relay to the plate.
-
Clamp the cable for the front socket at point (3) in the plastic eye for the bumper cover's mounting.
-
Guide the thin cable with the ground cable from the relay down to the same location as the cables for the engine block heater/passenger
compartment connector socket.
-
Clamp all cables together at point (4) with a tie strap from the kit.
Steps 24-33 apply to the XC90 with V8 engine
-
Route the cable in the same direction as the cable for the passenger compartment socket under the plate, under the left-hand headlamp. Route it
backwards along the left-hand side of the air filter and between the air filter and the fuse holder. Continue to pull it backwards, under the ABS
system and up between the cable duct and brake fluid reservoir.
-
Check that the cable does not chafe against sharp edges or moving parts in the engine compartment.
-
Route it along the cable for the passenger compartment connector socket over to the right-hand side of the car and down through the engine
compartment.
-
Clamp the cable securely the whole way with the cable for the passenger compartment connector socket using tie straps from the kit.
