XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Guide both cables into the hole in the cowl wall and press the rubber grommet into place in the hole, either by pulling it into place from inside the
passenger compartment, or carefully pressing it into place with a long large screwdriver/wide end of a short pry bar.
Note! These must not be sharp or they can damage the cables/rubber grommet
-
Adapt the length of the cable from the rubber grommet, at the installed clip and out in the engine compartment.
-
Press the cables for the passenger compartment connector socket into the installed clip. Make sure that the cable with the radiation shield is firmly
pressed into the clip and does not slide out.
Caution! Check that the cables are routed so that they do not come into contact with the alternator belt, or chafe against sharp edges in the
engine compartment.
-
Clamp the cable at the thicker cable using tie straps from the kit.
-
Reinstall the small protective panel in the wheel housing.
-
Reinstall the engine splash guard and torque tighten the screws to 25 Nm (18.5 lbf.ft.).
-
Remount the wheel and tighten the bolts to 140 Nm (103 lbf.ft.).
-
Connect and reinstall the left-hand headlamp.
Steps 34-37 apply to the XC90 with 5 and 6 cylinder engines
