XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Tighten the relay on the underneath of the side member. Use a screw from the kit in the same hole as the one in which the junction connector is
positioned
-
Connect the ground lead for the relay to the existing ground terminal at the front end of the side member. Tighten properly
-
Secure the ground lead excess by the cable for the front engine block heater socket. Use the tie strap (1) from the kit.
-
Tighten the single cable for the relay on top of the right front corner of the sub-frame. Tighten the cable together with the other wiring for the
engine block heater/passenger compartment connector socket
-
Secure the single cable for the relay at the existing wiring. Use the tie strap (1) from the kit.
-
Route the single cable along the cable to the passenger compartment connector socket and secure. Use the tie straps (1) from the kit.