XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
Turn the clips at the rear edge of the centre console 45°. Remove the right-hand side panel for the centre console (1). Pull the panel out at the rear
edge and then straight back
-
Remove the soundproofing panel (2). Remove the three screws (3) first. Then pry the panel from the three clips on the rear side. Pull the panel
backwards
-
Remove the panel (4) from the right-hand front door sill by pulling the upper front edge backwards. Then pull the panel upwards to release all the
clips.
-
Remove the locking sleeve over the joint between the cable and the passenger compartment connector socket. Pull the cable off
-
Remove the passenger compartment connector socket
-
Push the carpet at the right-hand front seat to one side to access the lead-in to the engine compartment. It is located to the left at the lower edge of
the soundproofing panel
-
Move the rubber grommet with the cable to the engine compartment.
-
Remove the seat cushion (1). First pull the front edge of the seat cushion up. Pull the cushion forwards. Then lift the seat cushion out
-
Fold the right-hand rear backrest forward.