XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Muffler: Service and Repair
Silencer, Front, Replacement
Silencer, front, replacement
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the muffler
Note! If there is no joint between the front and rear silencer then both parts must be replaced.
Caution! Suspend the front section of the exhaust pipe so that the catalytic converter is not loaded.
Applies only to first-time replacement.
Remove:
-
the nuts to the flange gasket, x2
-
the bolts to the bracket, x2
-
the bracket to the rubber mounting
-
the rubber mountings, x4
-
the silencer, front and rear in one piece
-
the flange gasket.
Caution! Suspend the front section of the exhaust pipe so that the catalytic converter is not loaded.
Applies to second-time or later replacements.
Remove:
-
the nut to the clamp between the front and rear silencer
-
the 2 x nuts for the flange gasket
-
the 2 x screws for the bracket
-
the bracket with the rubber mounting