XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
the control module.
Installation
Installing the damper motor module (DMM) for air distribution
Install:
-
the control module in position. Adjust the shaft journal so that it goes in
-
the 2 screws. Tighten alternately
-
the switch. Ensure that it is correctly positioned
-
the glove compartment. See Glove compartment, replacing See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair.
Note! Identify the damper motor module (DMM) for air distribution. See VIDA vehicle communication.
Finishing
Testing the climate control system
Carry out a performance test on the climate control unit. See: Climate system, performance test See: Testing and Inspection/Component Tests and
General Diagnostics/Climate System, Performance Test.
R.H.D
Damper motor module (DMM) air distribution, replacing
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Note! The damper motor module (DMM) for air distribution is only on the right-hand side of the car.
Removal
Removing the damper motor module (DMM) for air distribution