XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Tighten the screw to 60 Nm. Use wrench 999 7314 Spanner See: Tools and Equipment/999 7314 Spanner.
Wipe up any fuel spillage.
Position the wiring in the cut-out in the rubber ring
Note! Check that the arrow on the cover is between the markings on the tank. If the arrow is outside the markings the fuel gauge sensor will
give an incorrect value and the float may catch against the inner wall of the tank. If not: Slacken off the screw and adjust the position of the
sensor. Tighten as above.
Right-hand level sensor, continued
Install a new O-ring, lubricated with lubricant, P/N 1161580.
Press the right-hand level sensor down so that the fuel line connections are pointing forwards and to the right.
Check that the O-ring is not trapped.
Tighten the screw to 60 Nm. Use wrench 999 5720 Wrench See: Tools and Equipment/999 5720 Wrench.
Install the hoses on the level sensor.
Wipe up any fuel spillage.
Position the wiring in the cut-out in the rubber ring.