Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1694

Page 3
background image

-

Remove the tie straps from the cables

-

Disconnect the connector by releasing the locks on the front edge

-

Pull out and remove the connector.

Installation

Note! For tightening torques, see Specifications See: Specifications/Mechanical Specifications/Starting and Charging.

Installing the connector

Press the connector into the holder.

Central electrical unit, installing

Install:

-

the tie straps for the cables

-

the bottom section. Hook into place at the front edge

-

the screw in the rear edge. Tighten

-

the connector holder. Press into the catch.

Note! The rubber grommet

-

the screws

-

the engine cooling fan (FC) if applicable

-

the intermediate section. Check that all 3 clips have engaged.

Finishing work

Install:

-

engine control module (ECM) Engine control module (ECM), replacing See: Engine Control Module/Service and Repair and transmission control
module (TCM) Transmission control module (TCM), replacing See: Relays and Modules - Transmission and Drivetrain/Relays and Modules -
A/T/Control Module/Service and Repair 

-

the cover for the central electrical unit

-

the battery negative pole. Also see Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 1694

[PREV PAGE] [NEXT PAGE]