Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3303

Page 8
background image

Note! Check that the arrow on the cover is between the markings on the tank. If the arrow is outside the markings the fuel gauge sensor will
give an incorrect value and the float may catch against the inner wall of the tank. If not: Slacken off the screw and adjust the position of the
sensor. Tighten as above.

Install the level sensor left-hand fuel tank, see: Level sensor fuel tank left, replacing See: Level Sensor Fuel Tank Left, Replacing.

Finishing

Install on both sides:

-

the wiring in the sockets on the rubber seal

-

the cover over the level sensors, tighten the nuts to 6 Nm.

Connect the wiring and the connectors.
Fold the carpet down.

Install:

-

the center rear seat. See Upholstery backrest cushion center (second row), replacing See: Body and Frame/Seats/Seat Cover/Service and
Repair/Rear Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Center (Second Row), Replacing.

-

the outer rear seat. See Upholstery backrest cushion outer (second row) See: Body and Frame/Seats/Seat Cover/Service and Repair/Rear Seat,
Passenger Seat, Seat/Upholstery Backrest Cushion Outer (Second Row).

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3303

[PREV PAGE] [NEXT PAGE]