Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3310

Page 2
background image

Installation

Fuel gauge sensor

-

Position level sensor correctly

-

Install a new rubber seal

-

Connect the 2 connectors to the level sensor

-

Press tube system onto level sensor

-

Carefully position level sensor down with tube system and wires

-

Install level sensor attaching ring but do not tighten it

-

Press level sensor into position. Note position marks on cover and tank

-

Tighten lock ring, first by hand and then using special tool 999 5720 Wrench See: Tools and Equipment/999 5720 Wrench 

-

Install wire in rubber seal slots

-

Connect the connector

-

Install level sensor cover

-

The rest of the section is done in reverse order.

Additional information

To replace fuel gauge sensor on right side, see Right side fuel pump with level sensor See: Right Side Fuel Pump with Level Sensor.

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3310

[PREV PAGE] [NEXT PAGE]