XC90 FWD L6-3.2L VIN 98 B6324S (2007)
Headlamp Alignment Sensor: Service and Repair
Position sensor Bi-Xenon lamps, replacing
Note! ! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Location
The position sensor is by the rear axle on the left-hand side.
Preparatory work
Switch off the ignition.
Raise the car.
Removal
Disconnect the connector.
Remove:
-
The screw for the bracket
-
The nut for the lever
-
The position sensor and bracket.
Transfer the bracket to the new position sensor.
Installation
Install:
-
The nut for the lever
-
The position sensor and bracket
-
The screw for the bracket. Tighten.
Connect the connector.
Finishing work