volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Steering Mounted Controls Assembly > < Solenoid, Steering Gear, Replacement|Page 16294
Page 12
background image

Installing the exhaust pipes between front and rear catalytic converters 

Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Flanged Joint, Assembling.

Install:

-

both exhaust pipes

-

both exhaust pipes' nuts, M8.

Installing the protective cover under the engine

Install:

-

the protective cover under the engine

-

the bolts, M8, x6.

Fitting the bolts to the engine pad, right

Fit the bolts, x2. Tighten in accordance with: Tightening torque, B8444S See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical
Specifications/Tightening Torque.

Installing the wing liner

Install:

-

the wing liner

-

the plastic nuts, x2.

Removing the lifting tool

Remove the lifting tool 999 5716 Reading off tool See: Tools and Equipment/999 5716 Reading off Tool , kit 999 7070 Mounting See: Tools and
Equipment/999 7070 Mounting and lifting hooks 999 5460 Lifting hook See: Tools and Equipment/999 5460 Lifting Hook.

Fitting the bolts to the torque rod

Fit the bolts, M10 x2, at the suspension turrets on both sides.

Filling the power steering fluid reservoir

Fit the battery cable.

Warning! Avoid skin contact with the oil.

Install:

-

the hose with the clamp to the oil reservoir

-

the oil reservoir.

Fill the power steering fluid reservoir.

Note! For the correct oil grade use Volvo power steering fluid, part number: 116 1529-1.

Turn the steering wheel between both end positions several times.
Check and fill with oil as necessary. Apply the parking brake. Start the engine.
A: Turn the steering wheel slowly to the right, keep it at the end position for 2 seconds.
B: Turn the steering wheel slowly to the left, keep it at the end position for 2 seconds. Repeat steps A and B 10 times.

Finishing

Remove the oil filler cap.

Install:

-

the upper front engine casing

-

the oil filler cap.

Fit the front wheels on both sides in accordance with: Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Carry out wheel alignment in accordance with: Wheel alignment, checking / adjusting See: Alignment/Service and Repair.

Steering Mounted Controls Assembly > < Solenoid, Steering Gear, Replacement|Page 16294