XC90 FWD L6-3.2L VIN 98 B6324S (2007)
-
the nuts (1), M10 x4
-
the bolt (2), M10 x1.
Installing the metal protective cover
Install:
-
the protective plate on the steering gear
-
the bolt, M5, holding the protective plate on the steering gear, x1
-
the bolt, M6, holding the protective plate to the subframe, x1.
Installing the oil pipes to the steering gear
Install:
-
the pipes in the valve housing
-
the pipes' bolts on the valve housing in accordance with: Tightening torque See: Specifications
-
the bolt, M6, to the oil pipe bracket on the subframe
-
the pipe in the clips.
Installing the subframe at the rear edge
Raise the subframe's rear edge using a mobile jack.
Install the sub-frame's four screws together with the sub-frame's brackets and engine heater, if installed.
Use new screws. Lube the screws with oil.
Tighten acc. to: Tightening torque, B8444S See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening Torque. First
tighten the screws on the sub-frame's left side, then on the right.
Tighten the screws for the brackets M10.
Install the heated oxygen sensor's cables on the anti-roll bar
Fitting the lower bolt to the rear engine pad
Hint: Unscrew the upper nut in order to facilitate fitting the lower bolt.
Install:
-
the lower bolt to the engine pad, M10, x1
-
the heated oxygen sensor (HO2S) connectors on the subframe, x2.
Refit the protective plate under the steering gear.
Installing the steering arms to the wheel spindles
Install the steering arms to the wheels spindles. Use new lock nuts.
Tighten, see: Tightening torque See: Specifications. Use 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Installing the steering shaft joint, lower
Note! Always check carefully that the joint's screw hole is aligned with the slot in the steering gear's shaft.
Install:
-
the lower steering shaft joint
-
the bolt, M8
-
the connector to the solenoid.
