volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Quarter Window Glass|Service and Repair|Page 28638 > < Tailgate Windshield, Replacing|Page 28634
Page 1
background image

Quarter Window Glass: Service and Repair

Side window rear, replacing

Special tools:

951 2925 Rollout 2000 See: Tools and Equipment/951 2925 Rollout 2000 

As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential
information in the illustrations is always correct.

Removing the rear side window

Slide in a piece of tape into the PUR bead (1).
Insert a wire inserter in the upper front corner as illustrated.
Cut off approximately four meters of wire from the roll.
Secure the wire and pull the ends approximately 50 cm into the car.
Pull the wire around and downwards so it forms an eyelet around the outside of the windshield.
Check that the wire is at the bottom against the bead of adhesive.
Stretch the wire so it is still in position at the bottom. Pull in the excess from one end of the wire.

Quarter Window Glass|Service and Repair|Page 28638 > < Tailgate Windshield, Replacing|Page 28634