MDX V6-3.7L (2007)
26. Install the dowel pins (A) the differential housing assembly (B) and the six mounting bolts (C).
27. Tighten the six mounting bolts in a crisscross pattern in several steps.
28. Install the 83 mm shim (A) the bearing set plate (B) and the six mounting bolts (C).
NOTE: Install the bearing set plate, check to identification marks (D).
29. Tighten the six mounting bolts in a crisscross pattern in several steps.
30. Remove the dirt and oil from the sealing surfaces. Apply liquid gasket (P/N 08718-0001) to the sealing surface. Make sure you seal the entire
circumference of the bolt holes to prevent oil leakage.
NOTE:
-
You must assemble the housings with you do in 5 minutes after applying the liquid gasket. If not, the sealing surface must be cleaned, and the
liquid gasket reapplied.
-
Allow it to cure at least 30 minutes after assembly before filling the differential with fluid.
