RL V6-3.7L (2009)
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner and tension reducer connectors are properly plugged in.
-
Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
-
Check for any DTCs, and clear them using the HDS. If the DTCs will not clear, do the necessary troubleshooting.
-
Reset the power window control unit. See: Windows and Glass/Windows/Testing and Inspection/Programming and Relearning
-
Do the steering column position memorization. See: Steering and Suspension/Steering/Steering Column/Testing and Inspection/Component
Tests and General Diagnostics
Upper anchor bolt installation
Seat Belt Buckle
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures and wait at least 3 minutes
before beginning work.
2. Remove the front seat. See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation
3. Remove the center cover. See: Body and Frame/Seats/Seat Cover/Service and Repair/Front Seat Cushion Cover Replacement
4. Detach the cloth (A) of the seat cushion cover from the connecting rod (B), then detach the harness clip (C).
5. Disconnect the seat belt switch connector (A).
Driver's seat