Audi Workshop Service and Repair Manuals > A2 > Running gear, front-wheel drive | Front suspension, drive shafts | Wheel bearing (basic running gear): exploded view | Removing and installing front wheel hub/wheel bearing unit with wheel bearing housing installed

Pulling out wheel hub with wheel bearing

Note!

Place gearbox jack -V.A.G 1383/A- underneath (danger of accident from parts dropping out when wheel hub/wheel bearing unit is pulled out).

–	Insert 50 mm open-end spanner -3254- between -3253/1- and mounting surface on steering arm -arrow-.

–	Pull wheel hub together with wheel bearing out of wheel bearing housing. Hold tool assembly firmly while doing this.

1 -	Spindle -3253/3-

2 -	Axial roller bearing -3253/4-

3 -	Cross piece -3253/2-

4 -	Tube -3253/1-

5 -	Thrust plate -3253/6-

6 -	Open-end spanner (50 mm) -3254-