audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - selector linkage and pivot points on gearbox > < Removing and installing selector housing/selector rod

A3 Mk1

Removing and installing gear lever in selector housing
Removing and installing gear lever in selector housing
l  Selector housing is removed.
Removing
   
–  Detach selector rod -arrow-.
  A34-0062
–  Then remove bolt -1-.
–  Now remove sleeve -2- and damper -3-.
–  Then remove stop -4--arrows-.
  A34-0063
–  Push in all ball socket locating lugs in direction of -arrow-.
–  Pull gear lever carefully out of selector housing.
  A34-0064
–  Then push ball socket off selector rod in direction of -arrow-.
Installing
Perform installation in reverse sequence of removal.
Installing selector housing → Chapter.
Adjusting selector mechanism → Chapter
Tightening torques
  A34-0065
Selector rod to gear lever20 Nm
Gear lever stop to selector housing25 Nm

   

Exploded view - selector linkage and pivot points on gearbox > < Removing and installing selector housing/selector rod