Audi Workshop Service and Repair Manuals

Special tools and workshop equipment required

• ◆ 3309 Release tool

• ◆ 10-208 A Pliers

Removing

• ‒ Removing over-centre spring .
• ‒ Separate clutch pedal from master cylinder => Page 30-14 and push operating rod towards engine compartment onto stop.
• ‒ → Remove nut -A-.
• ‒ Pull bolt out until the clutch pedal can be removed.

Installing

Installation is carried out in the reverse sequence, when doing this note the following:

• ‒ Install over-centre spring => Page 30-5.
• ‒ → The retainer -A- must be fitted to the master cylinder operating rod -B-.
• ‒ Press clutch pedal in direction of arrow to engage. Ensure parts are correctly located.