A3 Mk1
Note
|
| 1 - | Bolt |
| q | 7x |
| q | 8 Nm and then turn 90° further |
| 2 - | ATF pump with piston “B2” |
| q | Exploded view → Chapter |
| q | Spare part is allocated according to gearbox code letters |
| 3 - | O-ring |
| q | Renew |
| q | Place on ATF pump |
| 4 - | Gasket |
| q | Renew |
| 5 - | Retaining ring |
| q | Not fitted in gearboxes with corrugated washer on last outer plate for brake “B2” (code letters → Chapter) |
| 6 - | Shim |
| q | Not fitted in gearboxes with corrugated washer on last outer plate for brake “B2” (code letters → Chapter) |
| q | Determining thickness of shims → Chapter |
| 7 - | Corrugated washer |
| q | Not fitted in gearboxes with shim and retaining ring for brake “B2” (code letters → Chapter) |
| 8 - | Outer plate “B2” |
| q | Quantity → Chapter |
| q | The thickness of the outer plate for adjustment of “B2” → Chapter only has to be determined in gearboxes with corrugated washer (-item 7-) |
| q | 1 or 2 outer plates can be installed |
| q | On gearboxes without corrugated washer (-item 7-), the thickness of the outer plate -B2- is always 3 mm. |
| 9 - | Inner plate “B2” |
| q | Quantity → Chapter |
| q | Soak new inner plate in ATF for 15 minutes before installing. |
| 10 - | Outer plate “B2” |
| q | Quantity → Chapter |
| q | Always install 2 mm thick outer plates |
| 11 - | Outer plate “B2” |
| q | Fit 3 mm thick outer plate to supporting tube |
| 12 - | Supporting tube for “B2” |
| q | For clutch pack “B2” |
| q | Varying length depending on number of inner plates fitted |
| q | Insert in such a way that notch locates on wedge of freewheel |
| q | Spare part is allocated according to gearbox code letters |
| 13 - | Spring cap |
| q | Install 3 spring caps before installing last outer plate |
| q | If 2 outer plates -item 8- are fitted, insert spring caps into both plates together |
| 14 - | Spring |
| q | 3x |
| 15 - | Spring cap |
| q | Install 3 spring caps after installing first outer plate |
| 16 - | Strainer |
| q | Not fitted on all gearboxes |
| q | Installed in return pipe of ATF cooler → Anchor |
| q | Gearbox housing must be provided with corresponding recess for installing strainer |
| 17 - | Gearbox housing |
| q | With clutches installed |
