A3 Mk1
Erasing fault memory
Erasing fault memory
Requirement:
After fault memory has been interrogated: |
→ Indicated on display: |
|
||
|
→ Indicated on display: |
|
||
|
→ Indicated on display: |
|
||
If the ignition was switched off e.g. between interrogating the fault memory and erasing fault memory, the fault memory is then not erased.
|
→ Indicated on display: |
|
||
If one or more faults are present.
|
→ Indicated on display: |
|
||
(The fault memory will be erased approx. 5 seconds. after the display appears.) The fault memory is now erased.
Wait about 1 minute before again interrogating the fault memory. |
→ Indicated on display: |
|
|
→ Print out with printer switched on: |
|
|||
Control unit -J217- was not given sufficient time to recognize faults.
When the fault memory is interrogated, the following display should appear: "No fault recognized!" |